Savant IP Audio Deployment Guide
Copyright © 2017 Savant System, LLC
009-1551-00 | 171121
13 of 34
4.2.
IR Wiring
SMA-5000
PAV-SIPA125/PAV-AIM7C
IR connections are made using 4-pin IR connectors supplied
with the device. The wire slips into the hole and locks with a
screw located at the top of the connector.
IMPORTANT! IR Wiring Precautions
–
Ensure that all IR emitters are within 15 feet (4.6 meters) from
the controller’s location.
–
Use of 3rd party flashing IR emitters with Talk Back is not
recommended. These types of emitters can draw voltage away
from the IR signal that can degrade IR performance.
IR Pinout
NOTE
:
While not shown in the diagram above, IR connections 3 and 4
follow the same wiring as 1 and 2.
IR connections are made using 6-pin IR Connectors supplied
with the device. The wire slips into the hole and locks with a
screw located at the top of the connector.
IMPORTANT! IR Wiring Precautions
–
Ensure that all IR emitters are within 15 feet (4.6 meters) from
the controller’s location.
–
Use of 3rd party flashing IR emitters with Talk Back is not
recommended. These types of emitters can draw voltage away
from the IR signal that can degrade IR performance.
IR Pinout
NOTE
:
While not shown in the diagram above, IR connections 4 to 6
follow the same wiring as 1 to 3.
4.3.
Speaker Wiring
The SMA-5000 and the PAV-SIPA125 use the same Speaker wiring. Speaker wiring is made using 4-pin Speaker Connectors supplied with the IP
Audio devices. The wire slips into the hole and locks with a screw located at the top of the connector. Speaker connectors accept up to 12AWG
speaker cable.
NOTES
:
–
Wire order shown does not represent any wiring standard. It may be different than other models.
–
While not shown in the diagram above, Zones 2 to 4 follow the same wiring as Zone 1.
