å
Turn four BLACK 9/16" FLAT HEAD SCREWS (BB) into the ENDS (A and B)
until the shoulder of the SCREWS rest on the surface of the ENDS.
å
NOTE: Do not overtighten the SCREWS.
å
Slide the END MOLDINGS (N) onto the ENDS (A and B). Line up the groove
in the MOLDINGS over the head of the SCREWS in the ENDS.
å
NOTE: If the MOLDINGS come up off of the SCREWS, remove them and
slide them on again.
Step 5
410412
www.sauder.com/services
Page 9
Apply pressure with your hands as you
guide the MOLDINGS onto the ENDS.
A
B
N
N
Shoulder
BLACK 9/16" FLAT HEAD SCREW
(4 used in this step)
BB
