Step 8
422600
www.sauder.com/services
Page 12
NAIL
(58 used in this step)
5N
Do not stand the unit upright
without the BACK fastened. The
unit may collapse.
Caution
å
Carefully turn your unit over onto its front edges.
å
Tighten the TWIST-LOCK® FASTENERS in the FRONT
PANEL (G) at this time.
å
NOTE: The BACK is reversible.
å
A perforation in the BACK (I) has been provided for access
to the SAFETY STRAP (60M). Unfold the BACK and punch
out the perforation and push the SAFETY STRAP through
the hole.
å
Make equal margins along the two long edges of the
BACK (I). The bottom edge of the BACK (I) and bottom
surface of the BOTTOM (F) should be even. Push on
opposite corners of your unit if needed to make it "square".
å
Fasten the BACK (I) to your unit using the NAILS (5N).
å
NOTE: Be sure to tap NAILS into the holes that line up
over the SHELVES (D and E).
å
Fasten the HINGES (16H) to the BOTTOM (F) and FRONT
PANEL (G). Use eight BLACK 9/16" LARGE
HEAD SCREWS (1S).
60M
F
G
16H
BLACK 9/16" LARGE HEAD SCREW
(8 used for the HINGES)
1S
I
These holes must line up
over the SHELVES (D and E).
Before fastening the
BACK, punch out the
perforation and push
the SAFETY STRAP
through the hole.
Tighten the
TWIST-LOCK®
FASTENERS in
FRONT PANEL.
