Step
å
Flip the drawer over onto the LEFT DRAWER SIDE (D88).
å
Insert a SLIDE CAM (AA) into the RIGHT DRAWER SIDE (D87).
å
Diagram 1. Insert the tabs on a DRAWER ACTUATOR (BB) into the slots in a EXTENSION SLIDE (P). You may need to
insert one tab fi rst, then the other.
å
Diagram 2. Visually check that the DRAWER ACTUATOR (BB) is seated in the SLIDE (P).
å
Diagram 3. If the DRAWER ACTUATOR is not seated, use your hammer to gently tap the SLIDE until the tabs are properly
seated in the slots.
å
Now, fasten the EXTENSION SLIDE (P) to the RIGHT DRAWER SIDE (D87). Use two GOLD 5/16" FLAT HEAD SCREWS (FF)
through holes #1 and #4.
å
Repeat steps 10 and 11 for the remaining drawer.
Step 11
102702
www.sauder.com/services
Page 16
BB
BB
P
2.
3.
Post
Seated
AA
Screw head - turn CAM to
line up holes in the SLIDES
with holes in DRAWER SIDES
P
4
1
2
3
D88
D87
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
FF
1.
BB
P
These tabs must
insert into the slots.
Slot
Open end
