Step 16
å
NOTE: You will need a Tape Measure in this step. Each BACK will use eight NAILS in this step.
å
Carefully lay your unit onto its front edges. We have provided a Nail Holder tool to use in this step for proper placement of the
NAILS. We will refer to parts of this tool as the bead, off set edge, and nail slot which is important to follow for proper assembly.
å
Diagram 1. Place a BACK (Q) into the lower edge of the LEFT END (B) with the top edge of the BACK (Q) against the
bottom surface of the TOP (T).
å
Diagram 2. Place the bead of the Nail Holder down between the BACK (Q) and LEFT END (B) 1-1/2" from the corner.
Place a NAIL (1N) into the nail slot of the Nail Holder. Tap the NAIL through the BACK and into lower edge of the LEFT
END. Remove the Nail Holder from the NAIL and completely tap the NAIL in with your hammer. Finish fastening the BACK
to the LEFT END with the hammer and Nail Holder placing NAILS approximately 5-1/2" apart.
å
Diagram 3 and 4. To fasten the remaining two edges of the BACK (Q) place the off set edge of the Nail Holder down.
Place a NAIL into the nail slot of the Nail Holder. Tap the NAIL through the BACK and into edge of LEFT UPRIGHT (E) and
SHELF (H). Remove the Nail Holder from the NAIL and completely tap the NAIL in with your hammer. Finish fastening the
BACK to the LEFT END with the hammer and Nail Holder placing NAILS approximately 5-1/2" apart.
å
Repeat this step for the remaining BACK (Q) fastening it to the RIGHT END (A), RIGHT UPRIGHT (D) and SHELF (H).
Q
Q
Bead
Nail slot
Nail
Holder
1-1/2"
1-1/2"
B
NAIL
(16 used in this step)
1N
D
E
A
T
1.
2.
3.
4.
H
Lower edge
Unfi
nished
sur
face
Unfi
nished
sur
face
419958
www.sauder.com/services
Page 20
Place packing material
under the BRACE (F)
for suppport.
F
Off set edge
Off set edge
Off set edge
Bead
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
