Step 9
Open end
å
Separate the EXTENSION SLIDES (35MC) from the EXTENSION RAILS (35MA) as
shown in the upper diagram below. Be prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (35MA) to the LEFT END/UPRIGHTS (B). Use four GOLD
5/16" FLAT HEAD SCREWS (3S) through holes #1 and #3.
å
NOTE: Use the exact holes shown in the ENDS (B).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged
diagram. Then, slide the inner cartridge of the EXTENSION RAIL in to fi nd the other hole
that lines up with the hole in the LEFT END/UPRIGHT. Turn a SCREW into this hole.
å
NOTE: The EXTENSION SLIDES (35MC) will be used later for the DRAWERS.
Open end
Push the black lever in and pull the SLIDE from the RAIL.
35MA
35MC
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
3S
B
B
V
424198
www.sauder.com/services
Page 13
1
2
3
1
2
3
