å
Separate the SMALL EXTENSION SLIDES (4) from the SMALL EXTENSION RAILS (3) as shown in the upper diagram
below. Be prepared, the parts are greasy.
å
Fasten two SMALL EXTENSION RAILS (3) to the ENDS (E and F). Use six BLACK 7/16" FLAT HEAD SCREWS (20).
through the holes shown.
å
NOTE: For each SMALL EXTENSION RAIL, turn a SCREW into the 1
st
hole shown in the diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that line up with the holes in the END. Turn a SCREW into
these holes.
å
NOTE: The SMALL EXTENSION SLIDES will be used later for the DRAWERS.
Step 3
E
F
BLACK 7/16" FLAT HEAD SCREW
(6 used in this step)
20
3
3
3
Open end
Groove
Groove
3
4
Page 7
www.sauder.com/service
423742
Open end
Open end
1
st
hole
Use these holes.
