Step 3
418647
www.sauder.com/services
Page 7
Cut out this rectangle to use as a "spacer"
3"
å
Diagram 1. Cut out and use the "spacer" at the top of this page to measure 3" from one end of the
INTERLOCK TRACK (22G). Position the INTERLOCK TRACK as shown.
å
ACTUATOR / TRACK ATTACHMENT:
å
Diagram 2. Tilt the fi rst edge of the INTERLOCK TRACK (22G) into the CABINET ACTUATOR (29G).
å
Diagram 3. Rotate the INTERLOCK TRACK and apply force to engage the second edge into the
CABINET ACTUATOR.
å
Diagram 4. Repeat the ACTUATOR / TRACK ATTACHMENT for the next CABINET ACTUATOR while
holding the previously completed CABINET ACTUATOR in its location hole. Repeat these steps until
all ACTUATORS have been attached.
å
Visually check that all INTERLOCK TRACK edges have been engaged into the CABINET ACTUATORS
as shown in diagram 3. Then, remove the INTERLOCK TRACK assembly from the END. You will use
these parts in the next step.
1
.
4
.
3
.
2
.
22G
22G
29G
29G
29G
22G
22G
29G
Do not slide the CABINET ACTUATORS
onto the INTERLOCK TRACK.
A
3"
Edge without HIDDEN CAMS
