SATO TXPEX6, Быстрый старт, Страница: 10 / 16

TXPEX6
3 Loading Ribbon
1. Grasp the tabs on the top and bottom of the Ribbon Stoppers and
move the Ribbon Stoppers back to the end of the Ribbon Shaft (inside
of the printer).
2. Lift open the print head block.
3. Leaving slack between the ribbon spools, place the ribbon onto the
ribbon shafts as shown below:
4. Lower the print head block and remove any slack in the ribbon.
5. Secure guide bracket and head lever to lock position.
Note: All Ribbon must be wound coated side out (CSO)/Ink outside.
The ribbon routing guide is located on the inside of the Top Cover
Loading Ribbon
5