CL6NX KITTING MANUAL
①
Pull the Rewind-lever
②
Set backing-paper
③
Push lever until inner-most
Set method of Label to Dispenser unit
④
Close the head
⑤⑥
While winding (pulling) backing-paper
lightly, close the Dispense-unit
<Note>
Confirm that it does not loosen the backing-
paper on Dispense-bar
If it has loosen (NG), perform
⑤⑥
again.
Set method of backing-paper to Rewind-core
①
②
③
Rewind-lever
④
⑤
⑥
OK
NG
(loosen)
platen
Thermal-head
Dispense-bar
Pressure- roller
Label Route
<Check and adjust after assembly Dispenser-kit>
<Preparation (set the Label, etc)>
(1) Set Pressure roller in center of used label.
(2) Set Label and Ribbon to Printer
Label: Peel off the label (about 30cm) from Label roll
(3) Open the thermal-head
(4) Open the Dispense-unit, pass thru the Label into it.
(5) Clip the edge of backing paper by Rewind-core-lever.
*Winding direction is CCW
：
refer to below procedure
(6) Close the thermal-head
(7) While winding the Rewind-core (pull backing-paper),
close the Dispense-unit
Set method of Pressure roller
Pressure-roller
SLIDE
Page. 10
DS KIT +
RW
MODEL only
Head pressure adjustment, please refer to
the Operation Manual.