CL6NX KITTING MANUAL
Label Route
<Check and adjust after assembly Dispenser-kit>
<Preparation (set the Label, etc)>
(1) Set Pressure roller in center of used label.
(2) Set Label and Ribbon to Printer
Label: Peel off the label (about 50cm) from Label roll
(3) Open the thermal-head
(4) Open the Dispense-unit, pass thru the Label into it.
<Method of mounting the label and ribbon>:see below
Page. 9
①
Close the thermal-head
②③
Close the Dispense-unit while pulling
backing-paper
④
Confirm that it does not loosen the
backing-paper.
If it has loosen (NG), perform
②③
again.
NG
OK
platen
Thermal
head
Dispense
bar
Pressure
roller
Set Label to Dispenser unit
①
③
POINT
②
④
DS KIT MODEL only
Set method of Pressure roller
Pressure-roller
SLIDE
Head pressure adjustment, please refer to
the Operation Manual.