SATO CL608e, Руководство по обслуживанию

Страница: 191 / 245

Page 9-19
Section 9. Optional Accessories
SATO CL608e/CL612e Service Manual
PN 9001079
Rev. B
9.5 Flash Memory Expansion Installation
STEP PROCEDURE
1. Switch the printer OFF and disconnect the power cable.
2. Remove (3) screws holding the left side cover to the printer. Raise the
access door and loosen the (2) screws on the inside top of the printer.
Lift off the left side cover to expose the main PCB. Fig. 9-23
3. Carefully press outward on the tabs on both ends of the Main PCB
Board Memory Frame to release the Standard Memory PCB. The Stan-
dard Memory PCB should lift by itself when released. Remove the
Memory PCB from the frame. Note the indexing notches. Figs. 9-24
4. Remove the Flash Memory Module from the anti-static bag handling the
module by the edges. Note the indexing notches. Insert the module
into the Main PCB Memory Frame at approximately 45
0
away from the
Main PCB Board. Gently push down to snap into position. Figs. 9-25
5. Replace the cover reversing removal steps.
6. Complete the Factory Reset Procedure.
STANDARD MEMORY PCB IN THE
MAIN PCB MEMORY FRAME
*
CAREFULLY PRESS OUTWARD
ON TABS ON BOTH ENDS OF THE
FRAME TO RELEASE THE MEMORY
PCB.
Figs. 9-24
INDEXING
NOTCHES
*
*
PRESS OUTWARD
PRESS OUTWARD