wide, press the LINE key to toggle the underline cursor to the Small
selection. If Large was selected, pressing the FEED key will print a
test label. If Small was selected, pressing the FEED key will display
the Print Size message. This screen allows you to adjust the width of
the test printout from a minimum of 1.6" (04 cm) to a maximum of
4" (10 cm) by using the LINE key to increment the displayed size.
Once the correct label size is entered, pressing the FEED key will in-
itiate a small test label print cycle.
4.
The printer will continue to print test labels until the FEED key is
pressed, placing the printer in the PAUSE mode. Pressing the FEED
key again will continue the test label printing cycle.
5.
To stop printing test labels, pause the printer by pressing the FEED key
and then turn power off. Turning power back on will place the printer
in the normal On-Line mode where it is waiting for print data.
Configuring the Printer
The CL408/412 comes from the factory with all Front Panel and Interface
DSW switches in the Off (or down) position. DSW-1 is located on the Se-
rial RS232 Plug-In Interface card. This configures the printer for the follow-
ing operation:
•
Thermal transfer printing.
•
If an RS232 Serial Interface is installed, it will be set for 9600 BPS,
no parity, 8 data bits, 1 stop bit and Ready/Busy Flow Control.
There are no interface settings for the Parallel or USB interfaces.
•
Label sensing set to detect label gaps.
•
Continuous label printing.
Other features can be enabled with different DSW switch combinations.
The function of each DSW switch is listed on a chart on the inside of the
front cover. A more detailed description is provided Section 2 of the Opera-
tor and Technical Reference Manual shipped with the printer. When chang-
ing configuration via the DSW switches, the power to the printer must be
cycled before the new settings become activated.
Computer Connections
The CL408/412 comes with Plug-In Interface card with the appropriate con-
nector. The type of Plug-In Interface card desired is specified at the time of
order and is shipped separately with the printer. It must be installed in the
printer before the computer connection is made.
CL408/412 Quick Guide
Page 7
PN 9001067 Rev A