Section 2: Installation
CG4 Series Operator Manual
Page 2-3
2.3 LOADING LABELS
2.3.1 Loading Roll media
1.
With the power supply off, pull the
cover open/close
latches
on both sides of the printer toward you to
unlock the
top cover
, and then open the
top cover
.
Note:
Make sure that the cover rests firmly so that it will not fall
forward and injure your hands.
2.
While holding the
media guide slide lever
, adjust the
width of the
media holder
to match the media size.
3.
Load the media onto the
media holder
.
4.
After pulling out the media, pass the media through the
media guides
and place the leading edge of the media
on top of the
platen roller
.
Note:
Make sure the printed side of the media is facing
upwards.
1
1
2
1
2
Media guide
slide lever
1
1
Media guides
Printed side should face
upwards
