MDR-4330AT USER MANUAL
17
83-00-001-DOC
Customers can add additional information to
the reader such as a physical location in the
customer ID number field. Refer to section
3.4.4 Changing the Reader’s System
Configuration of this User Manual.
Change made to the Reader’s System
Configuration will only take affect once the
reader is restarted
Tip: If you want to use the new name
immediately, simply switch the reader off
the on again to view the new name on the
Connection menu list.
When a Reader is connected to a host computer for the first time using a USB cable, the drivers
should automatically load, if they do not (Perhaps due to an older Windows OS) the Found New
Hardware Wizard will appear, perform the following steps.
1. In Found New Hardware Wizard tick “Yes”, this time only to search for software and
press “Next”.
2. In What do you want wizard to do? Tick “Install” the software automatically and press
“Next”.
3. Wait while the wizard installs the software: Linux USB Ethernet/RNDIS Gadget. Ignore
other message and press “Continue anyway”.
4. Press “Finish”.
5. Open the Connection menu to see a list of Readers and the new Reader identified by
Model Name-Serial Number on the list.
6. If you cannot find the new Reader on the list simply unplug the USB cable and plug it
again into the Reader USB device port. This time you should be able to see the
Reader’s Model Name-Serial Number.
Step 2. Start Reader Manager to view Readers found on the LAN
Reader Manager will use network broadcasts to look for active readers via USB and Ethernet.
All readers found on the LAN will be listed in the Dynamic Reader List as shown in the image
below.