A
B
C
D
Bike Bracket*
Mount Battery Back
Ratchet Cylinder End Cap
Detaching Lever
For mounting the Active 10 onto the handle bar
(F)
, stem
(G)
or crossbar
(H)
of a bike. When fitting onto handlebars, it is advised the solid end of the
groove is at the bottom of the Bike Bracket.
When fitting onto the stem or crossbar, you will need to change the direction
of the groove on the Bracket by rotating it 90 degrees. Undo the screws on
the underside of the Bracket
(E)
, twist the top and tighten the screws.
Getting Started
1. Clean the fixing area on the frame thoroughly with rubbing alcohol.
2. Remove the ratchet cylinder end caps
(C)
on both sides of the Bike
Bracket.
3. The Bike Bracket is suitable for frame tubing of up to 80mm in diameter.
There are two options for fitting, depending on the diameter of the bike
frame:
a. To fit to smaller tube diameters (35mm to 50mm), push the fabric band
through slot
(I)
.
b. To fit to wider tube diameters (50mm to 80mm), push the fabric band
through slot
(J)
, and then through slot
(I)
. This increases the band
flexibility so it can wrap around a wider area.
Fitting the Bike Bracket to the Bike Frame
1. Position the Bike Bracket on the desired area of the bike frame and wrap
the band around the frame tubing. Firmly tighten by hand and use the Allen
Key provided to tighten the ratchet cylinder in the direction of the arrow
(K)
. (Torque max. 16Nm).
2. To re-adjust or remove the fabric band, loosen the ratchet cylinder using
the Allen Key and turn in the opposite direction of the arrow. Make sure
the triangle on the metal ratchet lines up with the triangular groove on the
plastic casing to completely remove the fabric band.
3. If desired, cut off the excess band and carefully seal the end with a flame
to prevent fraying.
4. Push in the two end caps to secure the ratchet. (Slot the tab on the cap
into the wider gap around the ratchet cylinder and push down).
Note: Check ratchet and tighten after 1 week’s use.
The
Bike Mount
consists of the following components:
