ST-5810 Operation Manual
Copyright © 2019-2022 SatLink Elextronics
6
Frame or chassis ground
Alternating current
Direct current
Alternating or direct current
Caution
1.4 COPYRIGHT
All rights reserved. Reproduction, adaptation, or translation without prior written permission is prohibited, except as allowed
under the copyright laws. The information contained in this document is subject to change without notice.
SatLink and StarLink makes no warranty of any kind with regard to this material, including, but not limited to, the implied
warranties of merchantability and fitness for a particular purpose.
SatLink shall not be liable for errors contained herein or for incidental or consequential damage in connection with the
furnishing, performance, or use of this material.
1.5 SAFETY NOTICES
Observe the following safety precautions whenever you operate any SatLink instrument. Failure to comply with these and
other specific warnings and cautions is violation of SatLink’s safety standards of design, manufacturing, and intended use of
the measurement device. SatLink assumes no liability for the operators’ failure to comply with these precautions.
Do not use this product if it shows visible damage, fails to perform, has been stored in unfavorable conditions, or has been
subject to severe transportation stresses. Make the product inoperative and secure it against any unintended operation.
Contact your SatLink representative for assistance.
Do not operate the instrument in the presence of flammable gases or fumes.
To avoid possibility of severe injury or death, observe the following precautions when using any SatLink equipment:
Do not remove system cover, and do not preform electrical tests if there are signs of shipping damage to the outer
enclosure.
When connecting test cables to a line, do not touch the cable’s metal contact points, or allow the cable leads to
touch each other.
Use only the supplied power cords and connect only to a properly grounded wall outlet. Do not use extension cords
that do not have a protective ground conductor.
1.6 WARRANTY
This SatLink product is warranted against defects in material and workmanship for a period of 24 months from date of
shipment. During the warranty period, SatLink will, at its option, either repair or replace products which prove to be
defective.
For warranty service or repair, this product must be returned to an authorized service center designated by SatLink. The
buyer shall prepay shipping charges to SatLink or the service center and SatLink or the service center shall pay the shipping
charges to return the product. However, the buyer is responsible for all duties and taxes to receive the product after service
or repair.
SatLink warrants that its software and firmware are designated by SatLink for use with SatLink equipment, and will execute its
programming instructions when properly installed on that instrument. SatLink does not warrant that the operation of the
instrument, software, or firmware will be uninterrupted or error-free but strive to insure the best operating condition as per
specifications and datasheets.
