10/2019
PN 10900 /REVR
5
1. JOIN PANELS TOGETHER WITH CORNER MOLDING
•
SUPPORT THE REAR PANEL WITH A BOX AT LEAST
40” TALL BUT NOT WIDER THAN 41”.
IF ASSEMBLING
SINGLE UNITS,
USE THE WASTE TANK ON END
.
•
INSTALL RIVETS (
PN 11030
) FROM
REAR PANEL WITH WASHER (
PN 11315
)
ON THE SIDE PANEL.
2. ATTACH BASE TO PANELS
TIP BASE UP AND POSITION INSIDE PANELS. USING THE DRILL AND 3/8" HEX DRIVER BIT.
FASTEN PANELS TO BASE WITH LAG SCREWS (PN
13860
)
OR BOLTS PN 22384 BLOW BASE ONLY)
.
BLOWMOLDED BASE:
LOCATE DIMPLES & INSERTS ON BASE (see below).
FASTEN PANELS TO BASE WITH SCREWS & BOLTS. INSTALL REMAINING SCREWS IN HOLES.
DIRT BUSTER BASE:
FASTEN REAR PANEL FIRST. PANEL NEEDS TO BE FLUSH WITH TOP
OF RUNNER. USE CENTER SCRIBE LINE ON BASE TO ALIGN PANEL, INSTALL SCREWS.
REPEAT PROCESS ON SIDE PANELS USING SCRIBE LINES TO CENTER (see below)
NOTE: PANEL MUST BE FLUSH WITH BASE BEFORE FASTENING PANEL TO BASE.
IMPACT BASES
:
FASTEN REAR PANEL FIRST. USE THE CENTERING BUMP ON THE BASE
TO CENTER THE PANEL THEN FASTEN THE REAR PANEL WITH LAG SCREWS. **
REPEAT PROCESS ON SIDE PANELS, USE THE CENTERING BUMPS TO CENTER PANELS
AND INSTALL REMAINING SCREWS (see below).
**
NOTE: SIDE PANELS MUST BE FLUSH WITH SPACING RIBS AT EACH CORNER.
BLOWMOLDED
DIRT BUSTER BASE
(11)
(4)
DIRECTIONS
IMPACT BASES
CENTER BUMP
CENTER BUMP
SPACER RIBS
ANGLE
CORNER SCREWS
TO 45 DEGREES
INWARD TO MISS
CORNER
SCRIBE LINE
SCRIBE LINE
DIMPLES
INSERTS
BOLTS
SCREWS
(15)
(15)
DISTANCE FROM RIVET HOLE
TO MOLDING END IS SHORTER
AT TOP OF MOLDING
4
2
19
12
WASHER
20
17
1A
17
1D
1C
17
1B
