Satel VERSA Plus LTE, Руководство по установке

Страница: 29 / 40

SATEL VERSA Plus LTE 27
1. Enter the service code (by default 12345) and press the key.
2. Press in turn the keys. The service mode will start.
3. Press in turn the keys. The K
EYPADS ADDR
. function will start. All
LEDs designated with icons will start flashing in keypads and information on the current
address will be presented by means of:
LCD: displayed message – see Fig. 26,
LED: rapid flashing of the LED designated with the number corresponding to the keypad
address (for address 0 – LED 30) – see Fig. 27.
Fig. 26. Programming LCD keypad address.
Fig. 27. Programming LED keypad address. LEDs designated with numbers from 1 to 5 and
30 are used for address presentation (30 – for address 0). The LED corresponding to the
current address is flashing rapidly, the other ones are lit.
4. In the keypad in which a new address is to be set, press the key number corresponding to
the new address. The address change will be confirmed by four short beeps followed by
a long one.
5. Press the key to finish the function. The keypad will be restarted. The function will
be finished automatically after 2 minutes since it was launched.
5.13.2 Programming the address without entering the service mode
This way of address programming is useful when the keypad operation is blocked and
starting the service mode is impossible.
1. Power off the keypad.
2. Disconnect cables from the keypad CLK and DTA terminals.
3. Short the CLK and DTA keypad terminals.
4. Power on the keypad. The LEDs designated with icons will start flashing in the keypads
and information on the current address will be presented by means of:
LCD: displayed message,
LED: rapid flashing of the LED designated with the number corresponding to the keypad
address – see Fig. 27.
n=0...5 currently set keypad
address