6 VERSA
Plus
SATEL
1.7 Simple auto-arming deferment
Partition can be armed automatically by the
control panel is properly configured by the
timer on specific days at specific time. If the
installer, auto-arming can be easily postponed
from the LCD keypad during the auto-arming delay countdown. During the auto-arming delay
countdown the keypad displays a suitable message and, additionally, an audible signal can
be emitted.
Press the
key twice to defer the auto-arming.
1.8 User menu
Enter the code and press
to get access to the user menu. The list of available
on the state and configuration of the system.
functions depends on your rights, as well as
In order to quit the function and/or user menu, press
. The keypad will quit the menu
automatically, if 2 minutes have elapsed since the last keypress.
All user functions are described in the full user manual. Only a few selected functions are
discussed below.
1.8.1 Change own code
1. Enter the user menu and press in turn
.
2. Enter the new code, and then press
.
If a zone is not to trigger alarm, you can bypass it, when the partition to which the zone
e bypassing is useful, for example, when you want to leave
The inhibited zone will remain bypassed until disarming the partition it belongs to, or until
zone by the user.
1.8.2 Zone bypassing
belongs is disarmed. Zon
a window open when the system is armed or when a detector connected to the zone is out of
order and sets off false alarms.
Zone inhibiting
unbypassing the
Enter the user menu and press in turn
. Information on the bypassed
zones will be displayed. How it will be presented depends on the type of keypad.
d in the lower line – the zone name. You can scroll through the zone list using
LCD keypad
Shown in the upper line of the display will be a message to inform you that the zone is
bypassed, an
the
and
keys. There is a symbol in the upper right corner of the display:
– zone is not bypassed,
– zone is inhibited,
– zone is isolated.
Press any number key to change the displayed symbol to one of the following symbols:
– the zone is to be inhibited,
– the zone is to be unbypassed.
If you want to see the status of all zones which you can inhibit/unbypass, press
or
. The numbers around the display enable identification of the zones. Use the
and
keys to move the cursor. To inhibit/unbypass a zone, hover the cursor over it and
any numeric key. If you want to restore the previous way of presentation of the zone
ress
press
list, p
or
.
Press
to quit the function. The zones will be inhibited/unbypassed.
