8 VERSA
Plus
SATEL
The user can have two keyfobs:
433 MHz keyfob – supported by the 433 MHz keyfobs receiver expansion module or 433
r,
ecuted. The list of functions assigned to the
red the
MHz wireless system controlle
APT-100 bidirectional keyfob – supported by the ABAX wireless system controller.
A single keyfob enables up to 6 functions to be ex
buttons / combination of buttons should be obtained from the person who configu
keyfob settings when adding / editing a user. In the case of APT-100 keyfob, that person
should also provide information about functionality of the LEDs. The keyfob LEDs can be
used to confirm execution of functions, as well as to indicate the system status (pressing
a button on the APT-100 keyfob is accompanied by the LEDs flashing rapidly three times,
and in a little while the LED(s) may come on for 3 seconds to provide information).
3. Operating the alarm system by telephone
You can operate the alarm system by using a touch-tone (DTMF
makes the operation an easy job. To access the voice menu, c
) telephone. The voice menu
all the phone number of the
control panel. Establish, in consultation with the installer, the phone number to call to get
access to the voice menu.
3.1 Starting the operating by telephone
1. Call the control panel phone number. After the
beeps.
call is received, you will hear three short
The installer can configure the control panel in such a manner that the analog
telephone communicator will only go off hook after the recall. If this is the case, call the
number, but hang up after the number of rings which has been set by the installer. Call
again within three minutes. The call will be received.
2. En
foll
s to the interactive voice menu. If
ter the code from the telephone keypad and confirm by pressing #. 4 short beeps
owed by 1 long beep will confirm you have got acces
your code does not authorize you to get access, you will hear three long beeps in the
headset. If the code is incorrect, you will hear two long beeps in the headset.
The installer can allow for getting access to the voice menu from some defined phone
numbers without the code authorization (step 2 is skipped).
3. Me
telephone keys you should use to be able to operate the control panel.
ssages of the interactive voice menu will be played back. They will inform you which
3.2 Ending the operating by telephone
1. Press * key.
2. Press in turn the 0# keys. The control panel will go on-hook.
l panel will goes on hook automatically after one minute of idle state.
The contro
S control
4. SM
The alarm system can
control commands. The
be operated by means of the SMS messages containing suitable
SMS message must be sent to the number of the currently used SIM
card. The contents of control commands is to be programmed by the installer. Additionally,
the installer defines what the control panel is to do after receiving the control command, as
well as which users and from which phone numbers can operate the control panel using the
SMS messages.
