SATELLINE-3AS NMS / Epic NMS / VHF
User Guide, Version 3.0
65
11.1.1
Changing the settings in the Programming Mode
o
Connect cables (RS-232 cable to PC COM port, power supply cable to power supply).
o
Switch on the PC and start
SaTerm Lite
program (or other terminal program).
o
Open a terminal window and then choose ”Pr” (in case you are using some other
terminal program, set the serial port parameters of the program as follows: 9600 bits/s,
8 data bits, no parity, 1 stop bit, which is always the default in
Programming Mode
).
o
Connect PROG pin to ground (if using the NARS-1F adapter, slide the switch
downwards), the radio modem shifts into the
Programming Mode
. The screen should
look similar to the one shown in the picture below.
o
Make desired changes to the settings.
o
Save changes by pressing ”E” in the main menu. If you don’t want to save changes, press
”Q”.
o
Disconnect PROG pin from ground (if using the NARS-1F adapter, slide the switch
upwards), the radio modem returns to the
Data Transfer Mode
.
