SATEL INT-KNX
7
Group address
– group address, whose presence in the received telegram will enable
control of the given zone.
Zone
– the number of zone to be controlled by telegrams sent by the bus devices.
Receiving a telegram with the "On" command by the INT KNX module will violate the
zone (if it has already been violated, its status will not change), and receiving
a telegram with the "Off" command will restore the zone (if it has not been violated,
its status will not change).
Negation
– when this option is active, the logic of zone operation will be reversed (the
zone will be violated on receiving a telegram with the "Off" command by the INT KNX
module, and the zone restore will occur on receiving a telegram with the "On"
command.
Note:
The data are not read from / written to the module when using the
and
buttons in the main menu of D
LOAD
X program.
5. Specifications
Supply voltage ................................................................................................... 12 V DC ±15%
Standby current consumption ..........................................................................................35 mA
Maximum current consumption........................................................................................35 mA
Environmental class................................................................................................................. II
Operating temperature range.............................................................................-10 °C...+55 °C
Maximum humidity.......................................................................................................... 93±3%
Electronics board dimensions ................................................................................. 57 x 80 mm
Weight............................................................................................................................... 140 g
Note:
If the telegrams sent by the INT-KNX module are blocked by the line/area couplers,
use the so-called "dummy application" available from the manufacturer of BCU or
another company (e.g. GIRA large dummy application 900201). This will allow group
addresses to be added to the project. Do not load the application onto the device.
