SATEL GPRS-T4
19
Fig. 12. “CLIP / SMS messaging” tab.
Restore
– content of the SMS message that will be sent on the input restore. The message
may consist of up to 24 characters. It may not contain any diacritical characters. If the field
is left blank, the message will not be sent.
Add input voltage value to message
– if this option is selected, information on the current
voltage value at the input will be added to the SMS message about the analog input
status.
For the analog inputs, the messaging parameters are to be defined separately for each
of the defined thresholds.
4.3.6 “Reporting” tab
Indicate in the table in which situations the event code is to be sent to the monitoring station.
S1
– select this field if the event code is to be sent to the monitoring station 1.
S2
– select this field if the event code is to be sent to the monitoring station 2.
Violation/pass Code / Restore Code
– the event code that will be sent to the monitoring
station when the input status changes. 4 digits are to be programmed in the following form:
Q-XYZ, where:
–
Q
– digit 1 or 3 (1 – new event/disarming, 3 – new restore/arming),
–
XYZ
– 3-digit event code.
You can also make use of the code editor. To open the code editor, click on the
button,
available in the "EVENT" filed.
Violation/pass Partition / Restore Partition
– partition number which will be sent in
the event code. You can enter numbers and letters from A to F.
If events are to be sent in the form of two characters (partition number only), you
should not use the code editor.
