i
LIMITED WARRANTY
The manufacturer offers the customer an 24-month functional warranty on the instrument for faulty
workmanship or parts from date of dispatch from the distributor. In all cases, this warranty is valid for 36
months from the date of production. This warranty is on a return to factory basis.
The manufacturer does not accept liability for any damage caused by instrument malfunction. The
manufacturer accepts no responsibility for the suitability of the instrument to the application for which it was
purchased.
Failure to install, set up or operate the instrument according to the instructions herein will void the warranty.
Your instrument may be opened only by a duly authorized representative of the manufacturer. The unit should
only be opened in a fully anti-static environment. Failure to do so may damage the electronic components and
will void the warranty.
NOTE
The greatest care has been taken to manufacture and calibrate your instrument. However, these instructions
do not cover all possible contingencies that may arise during installation, operation or maintenance, and all
details and variations of this equipment are not covered by these instructions.
For additional information regarding installation, operation or maintenance of this instrument, contact the
manufacturer or your local representative or distributor.
IMPORTANT
Please read the instructions in this manual before performing installation, and take note of the
following precautions:
1.
Ensure that all incoming AC power and other power sources are turned OFF
before performing any
work on the instrument. Failure to do so may result in serious or even fatal injury and/or equipment
damage.
2.
Before connecting the instrument to the power source, check
the labels on the
side of the
instrument to ensure that your instrument is equipped with the appropriate power supply voltage, input
voltages, currents, analog output and communication protocol for your application.
3.
Do not
connect the instrument to a power source if it is damaged.
4.
Do not
expose the instrument to rain or moisture.
5.
The secondary of an external current transformer must never be
allowed to
be
open circuit when the
primary is energized. An open circuit can cause high voltages, possibly resulting in equipment damage,
fire and even serious or fatal injury. Ensure that the current transformer wiring is made through shorting
switches and is secured using an external strain relief to reduce mechanical strain on the screw
terminals, if necessary.
6.
Setup procedures must be performed only by qualified
personnel familiar
with
the
instrument and
its associated electrical equipment.
7.
DO NOT insert or remove I/O modules if the instrument is ON.
8.
DO NOT open the instrument under any circumstances.
)
Read this manual thoroughly before connecting the meter to the current carrying circuits. During
operation of the meter, hazardous voltages are present on input terminals. Failure to observe
precautions can result in serious or even fatal injury or damage to equipment.
