Satchwell HOTFLO, Инструкция

Страница: 6 / 17

6
Section 2: Assembly – Main Frame:
NB: Assess the angle of the roof & determine which of the below assemblies will be suitable.
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Cradle assembly – bolt inside, washer and nut outside Assembled Main Frame
Start by laying out the components:
•
A to D of the main frame, and
•
2 x component H on a flat surface as indicated
left.
Use a tape measure to determine the component length.
Using the M6 x 16 mm Bolts, nuts and washers, assemble
A2 to A1 , using component H – bolt inside, washer and
nut outside. Only finger tighten the bolts, nuts and
washers. Repeat the process for the other vertical leg.
Assemble B1 onto A2 using the M6 x 16mm bolts, nuts and washers supplied–
bolt inside, washer and nut outside. Only finger tighten the bolts, nuts and
washers.
Repeat the process for the other side.
Assemble B2 x2 onto A1 using the M6 x 16mm bolts, nuts and washers
supplied. – Mirror assembly – bolt inside, washer and nut outside. (Angles
facing each other)
Only finger tighten the bolts, nuts and washers
Assemble C onto A1 using the M6 x 16mm bolts, nuts and washers
supplied – cradle longest arm facing towards panel / bottom of main
frame. These bolts, nuts and washers can be fastened properly and in the
correct manner.
Repeat the process for the other side