Electromagnetic Compatibility
C
Marking
The printer complies with the following
EC Directives and European Standards:
2004/108/EC “Electromagnetic Com-
patibility (EMC)” Applicable European
Standards: Limitation of emissions:
In accordance with product standard
EN 61326-1 Class B (residential area)
Defined immunity to interference:
in accordance with product standard
EN 61326-1 (industrial environment)
Note: The operator shall be responsible
for any modifications to Sartorius
equipment and for any connections
of cables or equipment not supplied by
Sartorius and must check and, if neces-
sary, correct these modifications and
connections. On request, Sartorius will
provide information on the minimum
operating specifications (in accordance
with the standards listed above for
defined immunity to interference).
Council Directive 2006/95/EC:
“Electrical equipment designed for use
within certain voltage limits”
Applicable European Standards:
EN 61010-1 Safety requirements for
electrical equipment for measurement,
control and laboratory use Part 1:
General requirements If you use electri-
cal equipment in installations and under
ambient conditions subject to stricter
safety standards than those described in
the manual, you must comply with the
provisions as specified in the applicable
regulations for installation in your
country.
Using the Printer in Legal Metrology
The German National Institute of
Physics and Metrology (PTB) has issued
an independent test certificate for the
YDP10-0CE (see certificate for number).
With this certificate, the printer is per-
mitted for use in legal metrology in the
EU and the EEA. This applies only when
the printer is connected to a weighing
instrument that has an EC type approval
certificate, or a national equivalent,
verifying that the weighing instrument
is verifiable for legal metrology.
If the weighing instrument has one or
more display digits marked (e
=
d), the
printer must mark these digits as well;
for example, with brackets or inverse
printing. This does not apply for weigh-
ing instruments of accuracy class I with
a verification scale interval e = 1 mg
and a scale interval of d < 0.1 mg.
For weighing instruments with e = d,
marking digits is not permitted.
Data output from the weighing instru-
ment must be configured so that the
marking of digits is passed to the printer
and included on the printout.
If the printer is subsequently connected
to a verified weighing instrument already
in use in legal metrology, notify your
local weights and measures inspection
office or contact your local Sartorius
service center if you wish to have the
data printer configured and prepared
for verification for use in legal metrology.
The above does not concern printers
that are immediately used in legal
metrology.
15
