~ 19 ~
Auto Power ON Jumper
You can use JP1 (2.54mm pitch) to select to enable or disable the auto power on
function.
Clear CMOS Jumper
This mainboard contains a jumper (CMOS1, 2.54mm pitch) that can clear CMOS
data. If the CMOS data becomes corrupted or you forgot the supervisor or user
password, clear the CMOS data to reconfigure the system back to the default
values stored in the ROM BIOS.
Pin
Settings
1-2
Disable.
Press power button manually to power on after
power input is connected to power source (Default)
2-3
Enable.
Automatically power on when power input is
connected to power source
To clear CMOS data, please follow the steps below.
1.
Turn off the system.
2.
Change the jumper from “1-2” to “2-3” position for a
few seconds.
3.
Replace the jumper back to the “1-2” position.
4.
Turn on the system and hold down the <Del> key to
enter BIOS Setup.
Settings:
1-2: Normal (default)
2-3: Clear CMOS
Settings:
1-2: Disable (default)
2-3: Enable
1
3
3
1
Note:
When use clear CMOS function, the DC jack and the 4-pin power connector shouldn't
be connected to any power source.