Attach leg (C) to support bars (E) on the top and bottom with large
bolts and barrel nuts, now attach leg (D) to support bars (E) as shown
in (figure 2) below. make sure screw inserts are facing each other
Tie both ties around the support bars securely. The
stand needs to be placed on a horizontal floor.
Please see the picture to the right (fig 3)
Stage 2 assembly of the leg part 2
Assembly instructions
Stage 3 assembly of the stand
Now take leg part (1) and place inside leg part (2) as is on image on (page
1), and insert small bolt (2) into the middle and put washer (6) in-
between the legs and screw into position and do the same on the other
side now the crib feet are ready to lock into position with lock bolts (4)
Fix the Fabric to the frame by putting the sides over
the support bar and zipping up. Repeat this
procedure for the two ends by placing the ends
over the straps. Please see the picture (right)
place
the wooden base inside the crib making sure it is
secure and level.
Please note red internal stitch
line denotes that the mattress must not exceed
this height as is a legal standard requirement.
Figure 3
Figure 4
3
Figure 2
