1 2
3 4
14
The Sapling Company, Inc.
1633 Republic Road
Huntingdon Valley, PA 19006
USA
P. (+1) 215.322.6063
F. (+1) 215.322.8498
www.sapling-inc.com
Flush Mount Installation
1) Install the flush mount housing in the wall. Leave
at least one inch between the top of the housing
and ceiling. Confirm that the bottom of the housing
is level with the floor.
3) Detach the filter from the clock display board by
pressing inward on the red tabs.
4) Attach a data cable to the port on the right side
of the circuit board. If the clock is able to access the
Internet, it will begin to correct itself. Make a note
of the clock’s Serial Number, which should be on a
white sticker above the port. Add this information
to your tracking chart.
2) Run a CAT5 or CAT6 data cable from a PoE
switch or PoE injector to the housing. Confirm that
the switch or injector, and either an NTP server or
internet modem, are connected to your network
router. The clock-side of the cable should terminate
in a male RJ45 connector.
KNOW YOUR NETWORK
Make sure that your network firewall is set to
allow communication between the clocks and
NTP servers. This means that Ports 80, 123,
and 1777 must be open.
