devices should be shielded or relocated.
◦
RF Shielding: Your environment may tend to block transmission between the
wireless stations. This will mean high access speed is only possible when close
to the Access Point.
•
Some applications do not run properly when using the Wireless Router.
A:The Wireless Router processes the data passing through it, so it is not
transparent. Use the Special Application feature to allow the use of Internet
applications which do not function correctly. If this does solve the problem, you can
use the DMZ function. This should work with almost every application, but:
◦
It is a security risk, since the firewall is disabled.
◦
Only one (1) PC can use this feature.
•
I can’t connect to the Wireless Router to configure it.
A:Check the following:
◦
The Wireless Router is properly installed, LAN connections are OK, and it is
powered ON.
◦
Make sure that your PC and the Wireless Router are on the same network
segment.
◦
If your PC is set to “Obtain an IP Address automatically” (DHCP client), restart it.
◦
If your PC uses a Fixed (Static) IP address, make sure that it is using an IP
Address within the range 192.168.1.129 to 192.168.1.253 and thus compatible
with the Wireless Router’s default IP Address of 192.168.1.254. Also, the
Network Mask should be set to 255.255.255.0 to match the Wireless Router. In
Windows, you can check these settings by using Control Panel ~ Network to
check the Properties for the TCP/IP protocol.
•
The WinXP wireless interface couldn’t communicate the WEP with SAPIDO
BR476n’s wireless interface.
A:The default WEP of WinXP is Authentication Open System - WEP, but the WEP
of SAPIDO BR476n is only for Shared Key - WEP, it caused both sides couldn’t
communicate. Please select the WEP of WinXP from Authentication Open System
to Pre-shared Key - WEP, and then the WEP wireless interface between WinXP
and SAPIDO BR476n would be communicated.
5.7 Vista / WIN7 can not access USB disk if samba is "user mode"
a. Open Control Panel.
b. Choose Administrative Tools.
c. Click Local Security Policy.
d. Under Local Policies and Security Options
，
change Network security: LAN
Manager Authentication Level from “Not Defined” to “Send LM & NTLM responses”
