1.Clean the outside parts of the product.
2.Clean the nozzle
Pull out the nozzle softly and use smooth
cloth/sponge or toothbrush with kitchen
detergent to clean the nozzle.
Close the lid. Push the dismantlement button and
pull out the product as the arrow the figure. Then
the product will be dismantled.
(If the water flow is smaller than usual)
Clean the filter for both sides. Make sure to
disconnect the water supply hose during cleaning.
4. Remove the main body.
Use a smooth sponge/cloth with diluted kitchen
detergent to clean the product.Do not use the
following types: hydrogen chloride detergemt,
paining thinner, benzene, abrasive paper, polishing
agent, fragrance and insecticide, etc.
Insecticide
Abrasive paper
Paining thinner
Dismantlement button
Filter
Braided hoses
Product maintenance
5
As per figure A,Remove the old lever along the
axis direction.
As per figure B, insert the new lever rib into the
corresponding control valve slot. The installation
is completed with a “click” sound.
As per figure A, Pull out the tube and do not release
then remove the old nozzle along the axis direction
.
As per figure B, insert the new nozzle into the tube
along the corresponding slot. The nozzle
replacement is completed.
If water leaks from the two ends of water hose,
re-tighten the nuts to avoid water leaking.
Rotate the lever in the working position, clip out the
regulator from the inlet tube by pliers.
Press the new regulator into the bottom of the inlet
tube. The regulator replacement is completed.
Then rotate the lever back to non-working position.
A
B
Regulator
A
B
nozzle
1. Lever replacement
2.Nozzle replacement
3. Regulator
replacement
4. Water hose leaking solution
2
、
Clean the regulator o-ring (See the step 2 on the
page 5 to find how to remove and install the
regulator o-ring).
1
、
Regulator
3.
Clean the filter
and regulator
