2
1
Connect the cables from the ceiling.
Push the excess of connected cables into
the ceiling.
For details on the connections, see page 5.
2
Free the locks (E) on the base chassis.
3
Mount the camera unit using the two
base screws (J).
4
Push the sliding plate (D) in the arrowed
direction until it clicks, then connect the
pin connector cables from the camera
unit base to the circuit board.
The sliding plate must be between the
screws
(K)
and the base chassis for its
ends to be locked.
A
Set up the camera remotely (see the
back of this manual).
B
Check the settings screen or camera
angle on a portable monitor (see the back
of this manual).
1
Align the logo on the dome cover and
the mark (L) on the camera unit base.
2
Tighten the four screws (A) firmly using
the hexagonal wrench (large).
3. Mount the camera unit
E
J
Camera
unit
K
D
4. Adjust/Check the video image
from the camera
5. Install the dome cover
Accommodate the drop-prevention cable
neatly (no twists).
L
A
A
A
B
For customers using the option board
(heater: VA-50H)
For this unit, the main board
(A)
is sufficient
to raise the temperature. Always be sure to
remove the sub board
(B)
.
Do not adjust pan/tilt manually. They must be adjusted electrically.
L5BL2_XE(INSTALLATION).book 2 ページ ２００６年６月２３日 金曜日 午後７時９分
