1
Installing on the Ceiling
1
Loosen the four screws (A) using the
hexagonal wrench (large) and open the
dome cover.
2
Unplug the pin connector cables from
the circuit board.
3
While holding the chassis (B), pull out
the sliding plate (C) in the arrowed
direction.
The locks
(D)
on the base chassis come off
and free the camera unit.
1
Attach the cushioning sheet (F) to the
back of the camera unit base (G), open a
cable hole in the cushioning sheet, and
pass the cables through the cable hole.
2
Position the arrow (
y
) on the inner side
of the camera unit base (G) in the
direction of the lens.
The arrow is located roughly in the center of
the panning range.
3
Set the camera unit base (G) on the
ceiling and secure it by tightening
suitable screws and washers (H)
through the screw holes (4 places).
•
Length:
35 mm or more
•
Diameter:
3.5 to 5.0 mm
•
Height of screw head:
5 mm or less
(washer included)
1. Remove the camera unit
A
A
A
B
C
D
A
3
1
Camera
unit
2. Install the camera unit base
Make sure to tighten the screws properly.
Using screws of sizes other than
specified may cause the unit to fall.
1
2
3
F
G
H
H
L5BL2_XE(INSTALLATION).book 1 ページ ２００６年６月２３日 金曜日 午後７時９分
