INSTALLATION AND CONNECTION TO DVR
1
English
7
5
Place the DVR on the external disc unit.
(1) Insert the three legs of the DVR into the corresponding
holes in the top of the external disk unit.
The fitting should be positioned on the outside of the right
side of the DVR.
(2) Use the remaining screw (accessory) to secure the fitting
on to the right side of the DVR.
Tightening torque: 0.6 N•m - 0.7 N•m
6
Use the four screws removed in step 1,
to secure the DVR from the inside to the
external disc unit.
Tightening torque: 0.6 N•m - 0.7 N•m
z
If the HDD block was removed in step 4, reattach.
Tightening torque: 0.6 N•m - 0.7 N•m
7
Secure the cover on to the DVR using
the screws removed in step 4.
Tightening torque: 0.6 N•m - 0.7 N•m
Use the following procedures to connect the external disc unit
to the DVR.
1
Connect the USB cable and two power
cords.
Use the three power cord ties (accessory) to secure the power
cord to the power cord holder. (DVR: one tie, External disc
unit: two ties)
2
When you have finished making all the
other connections, make sure the
voltage is 120V - 240V AC and then
insert the power plug into the wall
outlet.
There is no power switch.
Attaching the external disc unit to the DVR
Fitting
Hole
Hole
Screw
Screw
Connection
Attach the core clamp (accessory) to the USB cable
near the connection with the DVR.
Power cord
(supplied with DVR)
USB cable
(supplied with external disc unit)
Power cord
(supplied with external disc unit)
Insert cable all the way so cables are not loose.
120 - 240 V AC
(50/60 Hz)
e05_l8hcc_us_7.fm Page 7 Friday, March 25, 2005 2:55 PM
