Sanyo Think GAIA PLC-XE45, Руководство пользователя

Страница: 59 / 69

59
Picture is not bright enough.
– Check if "Contrast" or "Brightness" are adjusted properly (see pages
31, 38).
– Check if "Image level" is selected properly (see pages 30, 37).
– Check the LAMP REPLACE indicator. If it lights, the end of lamp
life is approaching. Replace the lamp with a new one promptly (see
pages 56-57, 63).
– Check the Lamp control function (see page 59).
The color is strange.
– Check the Input signal, color system, video system, or computer
system mode.
– Adjust the Image level properly (see pages 30, 37).
Image is Left/Right reversed.
Image is Top/Bottom reversed.
– Check the Ceiling/Rear function (see page 44).
– Check the Ceiling function (see page 44).
The image is distorted or runs off.
– Check the "PC Adjustment" menu or "Screen" menu and adjust
them (see pages 26-29, 32-33, 40).
No sound
– Check the audio cable connection from audio input source.
– Adjust the audio source.
– Press the button (see page 23).
– Press the Mute button (see page 23).
– When the AUDIO OUT is plugged in, the projector's built-in
speaker is not available.
– Is the image projected? You will hear the sound only when the
image is projected.
Some displays are not seen during
the operation.
– Check the Display function (see page 41).
Auto PC adjustment function does
not work.
– Check the Input signal. Auto PC Adjustment function can not work
when 480p, 575p, 720p, 480i, 575i, 1035i, or 1080i is selected (see
page 27).
The setting does not remain after
turning off power.
– Make sure you selected “Store” after adjusting settings. Some
settings cannot be stored if not registered with “Store.”
Power management function does
not work.
– Power management function cannot work while "Freeze" or "No
Show" function is running.
Image disappears automatically
– Check the power management function in the Setting. The power
management is set to “On” at the factory.
Capture function does not work. – Check the connection and the Input signal to see if there is signal.
The Remote Control does not work.
– Check the batteries.
– Make sure no obstruction is between the projector and the remote
control.
– Make sure you are not too far from the projector when using the
remote control. Maximum operating range is 16.4’ (5 m).
– Make sure the code of the remote control is conformed to that of
the projector (see page 46).
Appendix