Sanyo Think GAIA PLC-WXU700, Руководство по обслуживанию

Страница: 30 / 132

-30-
Electrical Adjustments
1. Enter the service mode.
2. Receive the 16-step gray scale computer signal with
Computer2 [RGB]
mode.
3. Select group no. “
104
” item no. “
217
” (Red) or
“
223
” (Blue), and change Data values respectively to
make a proper white balance.
Confirm that the same white balance is obtained in vid-
eo and computer input.
9. White Balance adjustment [PC]
1. Enter the service mode.
2. Receive the 16-step grey scale computer signal with
Computer2 [RGB]
mode.
3. Connect an oscilloscope to test point “
TP35G
” (+)
and chassis ground (-).
4. Select group no. “
104
”, item no. “
220
” and change
data value to adjust amplitude “
a
” to be
1.2V
.
(a)
white level
white level
8. 50% White adjustment [PC]
1. Enter the service mode.
2. Receive the 50%-Whole Gray computer signal with
Computer2 [RGB]
mode.
3. Select group no. “
104
”, item no. “
76
” and change
data value to “
2
” to reduce the panel frequency.
4. Project only green light component to the screen.
5. Select group no. “
105
”, item no. “
10
” and change
data value to obtain the minimum flicker on the
screen.
6. Project only red light component to the screen.
7. Select item no. “
9
” and change data value to obtain
the minimum flicker on the screen.
8. Project only blue light component to the screen.
9. Select item no. “
11"
and change data value to obtain
the minimum flicker on the screen.
10. Select group no. “
104
”, item no. “
76
” and change
data value to “
0
” to reset the panel frequency.
7. Common Center adjustment
1. Enter the service mode.
2. Receive the 16-step grey scale composite video sig-
nal with
Video [Video]
mode.
3. To start the auto-calibration for Component adjust-
ment, select group no. “
260
”, item no. “
0
” and then
change data value from “
0
” to “
1
”. After the auto-cali-
bration completed, "OK" will appear on the screen.
6. Auto Calibration adjustment [Video]
Gain adjustment [Video]
1. Enter the service mode.
2. Receive the 16-step grey scale composite video signal
with
Video [Video]
mode.
3. Connect an oscilloscope to test point “
TP35G
” (+)
and chassis ground (-).
4. Select group no. “
20
”, item no. “
0
” and adjust the
amplitude “
a
” to be minimum by changing the Data
value.
(a)
White Level
below adjustment is performed when the above auto
calibration is failed.
1. Enter the service mode.
2. Receive the 16-step grey scale composite video sig-
nal with
Video[Video]
mode.
3. Connect an oscilloscope to test point “
TP35G
” (+)
and chassis ground (-).
5. Select group no. “
104
”, item no. “
220
” and change
data value to adjust amplitude “
a
” to be
1.2V
.
(a)
white level
white level
10. 50% White adjustment [Video]