Sanyo SHAKC64AGB, Инструкция по эксплуатации

Страница: 3 / 22

.
3
System Controller
D: ON button This button is for turning the selected air conditioner on.
E: OFF button This button is for turning the selected air conditioner off.
F: Operation lamp This lamp lights when the unit is turned on.
G: MODE button Use this button to select one of the following 5 operations:
(AUTO) : Used to automatically set cooling or heating operation.
Only for heat pump type
(Temperature range: 17 to 27°C)
(HEAT) : Used for normal heating operation.
Only for heat pump type
(Temperature range: 16 to 26°C)
(DRY) : Used for dehumidifying without changing the room temperature.
(Temperature range: 18 to 30°C)
(COOL) : Used for normal cooling operation.
(Temperature range: 18 to 30°C)
(FAN) : Used to run the fan only, without heating or cooling operation.
NOTE When the indication is displayed, you cannot change the mode from and
or to or and . To change the mode, turn off all units once then select the
mode again.
H: Temperature setting
buttons
: Press this button to increase the temperature setting.
: Press this button to decrease the temperature setting.
I: FAN SPEED button
(AUTO) : The air conditioner automatically decides the fan speed.
(HI) : High fan speed
(MED) : Medium fan speed
(LO) : Low fan speed
J: FLAP button 1. Use this button to set the airflow direction to a specific angle.
The airflow direction is displayed on the remote control unit.
Operation mode
(COOL) or (DRY)
(HEAT) or (FAN)
(AUTO)
Cooling mode:
Heating mode:
Number of airflow direction settings
3
5
3
5
CAUTION
In the Cool mode and Dry mode, when the flaps are set in a
downward position, condensation may form and drip around the
vent.
Do not move the flap with your hands.
NOTE
This function is available only for models X, XM, T and L Types.
( )
2. Use this button to make the airflow direction sweep up and down automatically.
Press this button several times until the ( ) symbol appears on the display.
NOTE
This function is available only for models X, XM, K, T and L Types.
NOTE
1) The flap setting can be performed only for units that have no remote controllers.
2) In the ALL or ZONE mode, no flap setting can be performed. If necessary, you
should select the GR mode and use the FLAP button.