DAB manual tune
1. To select manual tune, press and hold the
MENU/INFO
button until
the display shows “Manual ”.(F.1)
2. To enter the ensemble/multiplex, press the
SELECT
button, the
display will show the first station in the ensemble/multiplex.
3. Press the
or
buttons to move through the DAB channels, the
display will show “5A to 13F” and their associated frequencies. When
your radio locates a station group(ensemble/multiplex) on one of the
DAB channels, the name of the station group will appear in the
display.(F.2)
4. Press the or buttons to see what stations are present on the found
ensemble/multiplex, when you have located your desired station,
press the
SELECT
button, and at the same time, you will also exit from the manual tuning mode.
DAB secondary services
On some occasions you will see a “>” symbol appeared after the name of the station, this indicates that there are
secondary services available to that station. These secondary services contain extra services that relate to the
primary station. To select the secondary service, press the
SELECT
button.
FM radio
1. To select FM, press the
DAB+/FM
button, the display will show the station name or frequency.
2. To activate auto search up/down, press the or buttons, and then press the
SCAN
button once, it will start
scanning up/down the frequency band and stop automatically once a station has been found.
3. To activate manual search, press the or buttons.
In either DAB or FM mode, you can store up to 10 stations to the presets; this will enable you to get direct access to
your favourite stations.
1. To store a preset, first tune to your desired station, then press and hold the
PRESET
button until the display
shows the preset number and flash, you will have approximately 5 seconds to perform the next step. (F.3)
2. Press the or buttons to select your desired station preset number and then press the
SELECT
button to
confirm your selection. The display will show “STORED”.(F.4)
3. To recall a preset station, press the
PRESET
button once, then press the or buttons to select the stations
that you have stored, when your desired preset number and its associated frequency appears in the display,
press the
SELECT
button to confirm. If the preset hasn't been allocated a station, the display will show
“Empty”. (F.5)
STORING AND RECALLING PRESET STATIONS
F1
F2
F3
F4
F5
DISPLAY MODES
In FM mode
1. Press the MENU/INFO button once, the display will show the Time.
2. Press the MENU/INFO button twice, the display will show the Date.
3. Press the MENU/INFO button for longer than 2 seconds, the display will show SYSTEM.
In DAB mode
1. Press the MENU/INFO button once, the display cycle thorough the following display modes:
2. Press the MENU/INFO button for a long time enter into tune select menu, then press the or button, the display
will cycle through the following display mode:
Press the SELECT button to active your desired station.
MANUAL
DRC
PRUNE
SYSTEM
DAB/DAB+
Time
Date
4
Signal strength
DLS
The display will show a slide bar to indicate the signal strength, the stronger the signal, the longer the bar will be from
left to
right.
DLS stands for Dynamic Label Segment which is a scrolling message that the broadcaster may include in their
transmissions. The message usually includes information such as programme details …etc.
