Sanyo PLC-XU8, Руководство по обслуживанию, Страница: 9 / 120

-9-
The LAMP REPLACE indicator will light yellow when the total lamp used time (Corresponding value) reaches 3,000
hours. This is to indicate that lamp replacement is required.
The total lamp used time is calculated by using the below expression,
Total lamp used time (Corresponding value) =
t
eco +
t
normal x 2
t
eco : used time in the Eco mode
t
normal : used time in the Normal mode
You can check the lamp used time following to the below procedure.
1
Press and hold the oN/oFF button on the projector for more than 20 seconds.
2
The projector used time and lamp used time will be displayed on the screen briefly as follows.
How to check Lamp Used Time
Be sure to reset the Lamp counter after the lamp is replaced. When the Lamp counter is reset, the LAMP RE-
PLACE indicator stops lighting.
Press the MENU button to display the On-Screen Menu.
Use the Point
7 8
buttons to move the red framed
pointer to the Setting Menu icon.
Use the Point
ed
buttons to move the red framed point-
er to Lamp counter and then press the SELECT button.
A dialog box appears showing the total accumulated time
of the lamp usage and the reset option. Select Reset and
the “Lamp replacement counter Reset?” appears. Select
[Yes] to continue.
1
2
Another confirmation dialog box appears, select [Yes] to
reset the Lamp counter.
3
Resetting the Lamp Counter
✔
Note:
• Do not reset the Lamp counter without implementing lamp
replacement. Be sure to reset the Lamp counter only after
replacing the lamp.
Lamp counter
Select Reset and the “Lamp
replacement counter Reset?
” appears.
Select [Yes],
then another
confirmation
box appears.
Select [Yes] again to reset the
Lamp counter.
Maintenance
Counter
Projector
525H
Lamp
Normal 150H
Eco 375H
Corresponding value 675H
total lamp used time
Projector used time