Sanyo PLC-XU116, Руководство пользователя

Страница: 306 / 399

63
E-mail setting
L When lamp corres. value reaches preselect use time:
The projector sends a free message when the lamp use time (Corresponding value) reaches the
preselected lamp use time. It can be used for preparation of the lamp replacement and the maintenance
required.
TITLE: Message from projector
10-03-2007 00:59
Projector Model Name:
model name
TCP/IP: 192.168.1.201 Projector Name: Proj05
It sends you following message.
*The accumulated lamp use time reaches 1800 hours.
Prepare for the lamp replacement.
Discretional messages
L When internal PJ temperature is too high:
The projector let users know the information which thermal sensors inside the projector detected the
abnormal temperature risen and so the projector was turned off. Please refer to item "Power control
and status check" (
p.68) for the location of the sensors and each temperature . Also see the owner's
manual of the projector for further details.
TITLE: Message from projector
10-03-2007 00:59
Projector Model Name:
model name
TCP/IP: 192.168.1.201 Projector Name: Proj05
It sends you following message.
*The Projector lamp is turned off, because internal Projector temperature is too high.
Wait for the completion of the cooling process and make sure the projector has been
turned into Standby. Then turn the projector on again.
If the Indicator continues flashing, check the air filter for dust accumulation.
[A] 81.5 degrees fahrenheit [B] 134 degrees fahrenheit [C] 95.6 degrees fahrenheit
Temperature of Sensor B is too high.
L When PJ needs service::
TITLE: Message from projector
10-03-2007 00:59
Projector Model Name:
model name
TCP/IP: 192.168.1.201 Projector Name: Proj05
It sends you following message.
* Maintenance requirement from Projector is detected.
Check up LED status of projector and consult with the dealer.
MAIN, P-FAIL OK
MAIN, 1.8V OK
MCI, P-FAIL NG
Maintenance requirement from Projector is detected. Unplug the AC power cord and plug it again, and
then turn on the projector to verify the operation. If the problem still persists, unplug the AC power cord
and ask servicing to a qualified service personnel.
Error information