Sanyo PLC-XF47, Руководство пользователя

Страница: 51 / 82

51
On start
When this function is set to “On,” the projector will be
automatically turned on just by connecting the AC power cord to
the wall outlet.
Note:
• Make sure that the main switch is ON, otherwise the On start
function does not work.
• Be sure to turn off the projector properly (see “Turning Off
the Projector” on page 24). If the projector is turned off in
the incorrect sequence, the On start function does not work
properly.
Power management
Time left before the lamp is off
Press the SELECT button at Power
management and the dialog box
appears. Use the Point
buttons to choose one of the three
options.
Press the Point
button to select
the timer, and then use the Point
buttons to set the timer
For reducing power consumption as well as maintaining
the lamp life, the Power management function turns off the
projection lamp when the projector is not used for a certain
period.
If the input signal is interrupted and no button is pressed for
more than 30 seconds, the timer display with “No signal”
appears. It starts the countdown until the lamp is turned off. The
countdown time can be set between 1 and 30 minutes.
Use the Point
buttons to set the countdown timer.
Select one of the following options:
Ready . . . . When the lamp has been fully cooled down, the
READY indicator starts blinking. In this condition,
the projection lamp is turned on if the input
signal is reconnected or any button on the side
control or remote control is pressed .
Shutdown . . When the lamp has been fully cooled down, the
power is turned off.
Off . . . . . . . Power Management function is off.
Power management
Note:
• Factory default is “Ready: 5 min.”
Setting
RC sensor
Select a location of the infrared remote receiver of the remote
control. See “Remote Control Receivers and Operating Range”
on page 15 for details.
Both......... Activate both the front and back receiver.
Front ........ Activate only the front receiver.
Back......... Activate only the back receiver.