Sanyo PLC-WXU700A, Руководство пользователя

Страница: 323 / 393

84
Chapter 7 Controlling the projector
Status
If some of the registered projectors are disabled by
some reasons (such as disconnecting the power source,
disconnecting the LAN cable, disconnecting from the network),
control changes will continue to be effective for the projectors
that are still active. At the same time, the deactivated projectors
are excluded from the multi-control. The status of the registered
projectors are indicated under the projector name. See the
table below for status indications.
If the multi-controlled projector is in the standby mode, items of "PC adj.", "Control" and "Setting" cannot be
operated.
It is recommended that a specified projector should be chosen for setting as a master when you use this multi-
control function. The control for the multi-controlled projectors will become too complicated operation if this
function is used for each projector.
If the registered projector is not connected to the network, it will take a while to complete the multi-control
operation because of waiting for the response from each registered projector.
There are some disabled items in the multi-control function for the light mode.
Change the mode of the registered projector
To change the mode of the registered projector, select a mode with the pull-down menu button under
the IP address of the target projector and then click Set button.
Status Description
(blank)........................The projector is connected to the network correctly
No connect ..............The projector may not be connected to the network. Please check the connection and network
configuration of this projector.
PIN code error .................The PIN code is incorrect. The PIN code for the multi-controlled projectors must be the same.
Change the PIN code of this projector to the common PIN code. (p.32, p.42)
File Error.................... Not displaying the images. Check if this projector is using the Network Capture function, or in
the standby mode.
* The projector updates the status at the time when the multi-control function is executed.
Mode Operation
Control....................... Controlling the projector
Control & Image
.............. Controlling and displaying images
Image......................... Displaying the images
OFF.............................. Excluding from the multi-control
Delete ........................ Deleting from the multi-control
Status
* The multi control item is not available with the light mode.