Sanyo HEC-DR5700, Инструкция по эксплуатации

Страница: 18 / 32

17
(Remote control display)
Massaging
rollers
MASSAGING (WHOLE BODY SENSOR AUTOMATIC COURSES) (continued)
Displays the aim of massaging positions, the type of
massaging, the stiffness, body pressure and the
remaining massaging time on the remote control.
The explanation uses promoting blood
circulation as an example.
SENSOR MASSAGE
Massaging according to the degree of stiffness
Displays the position where the
stiffness has been detected.
Adjusting the strength of massage
NOTE
Massaging operation and display of remote control Measurement of shoulder position
Massaging rollers move up and down
to measure the position of shoulder.
(Sit deeply on the massage chair and raise your
head slightly. The matching of the position of
shoulders may not be possible if the head is
leaning on the back rest.)
Massaging operation at recognized
position of shoulder.
Check that massaging rollers match
the position of your shoulder.
If not, when the lamp of is
flickering (a beep sounds),
adjust the position by pressing
the POSITION ADJUST buttons.
The massaging rollers are
moved up or down by 1cm
each time the POSITION
ADJUST button is pressed.
When it is difficult to
adjust with POSITION
ADJUST button, move
your body for adjustment.
The height that can be
adjusted is between
approx. 150 to 180cm.
Decides the position of shoulder.
Measurement of the degree of stiffness.
The sensor will display the positions of stiffness (those
where stiffness has been detected) by measuring the
amount of perspiration from your hand in reaction to
sensor massage.
When measuring the degree of stiffness, the result is
displayed by the ring around the REPEAT! (See page 7)
When the measurement is over, a beep sounds.
Each time the UPPER (DRUM ROLL) button is pressed, the strength of
upper body (drum roll) massaging can be adjusted in five stages.
(The strength is displayed by the lamp on the remote control.)
Each time the LOWER BODY STRENGTH ADJUST button is pressed, the
strength of lower body massaging (air) can be adjusted in three stages.
(The strength is displayed by the lamp on the remote control.)
＊
If you continue to press the “ ” button until the illumination of the
lower body strength scale turns off, you can turn off the massaging of
the lower body. If you press the “ ” button, the massaging will
resume.
When it is felt that the massaging on the soles or calves is too strong even when reducing the
strength of lower body (air) massaging, put a towel etc. on those massaged parts.
Position too high
Position too low
Appropriate position
●
●
●
●