(10) Replacement of massaging motor section
1, Disconnect connectors of massaging motor cord.
2, Detach BELT (MOMI).
Photo.13
3, Unscrew one motor fixing screw.
Photo.13
4, Unscrew two STAY A (MOTOR M) set screws and
detach massaging motor section.
Photo.13
5, Detach PULLEY (MM) from massaging motor
shaft and unscrew three massaging motor set
screws.
Photo.13
Precautions for Assembly
Securely fix STAY A with two STAY A set screws so
that holes of frame coincide with those of STAY A
(MOTOR M) (see round section of Photo 14).
Photo.14
Adjust and mount PULLEY (MM) so that grooves of
PULLEY (M) and PULLEY (MM) are aligned in a straight
line.
Photo.14
Take care to prevent grease from adhering to
driven sections such as belt, etc. (bad operation
occurs due to slip).
(11) Replacement of gear box section
1, Detach massaging belt.
Photo.15
2, Unscrew two STAY (HARNESS) set screw and
remove STAY (HARNESS).
Photo.15
3, Unscrew one HOLDER (MAGNET WIDTH) set screw
and detach HOLDER (MAGNET WIDTH) from shaft.
Photo.15
4, Remove RING C 13 from shaft.
Photo.15
5, Slightly unscrew four SAHFT M set screws on
the right.
Photo.13
6, Unscrew four GEAR BOX ASS'Y section fixing screws
and detach GEAR BOX ASS'Y section from shaft.
Photo.16
7, Detach PULLEY (M) from GEAR BOX ASS'Y.
Photo.16
8, Unscrew two pieces each of stay set screw
on both sides of GEAR BOX ASS'Y and remove
STAY (GEARCASE R and GEARCASE L).
Photo.15
Photo.13
Massaging motor
BELT (MOMI)
STAY A (MOTOR M)
Frame
STAY A (MOTOR M)
PULLEY (MM)
Photo.14
Cord (BLUE)
SCREW
SCREW
SCREW
SCREW
In perfect alignment
of the holes
SCREW
RING
Ｃ
13
HOLDER (MAGNET WIDTH)
STAY (HARNESS)
Photo.15
GEAR BOX ASS'Y
PULLEY (
Ｍ
)
Photo.16
BELT (MOMI)
SCREW
SCREW
SCREW
SCREW
SCREW
- 16 -
Replacement Procedure
HEC-DR21
(TAIWAN)
