1 Notice
SANYO is a registered trademark of SANYO Electric Co., Ltd.
and is used by Funai Electric Co., Ltd. and Funai Corporation, Inc.
under license from SANYO Electric Co., Ltd.
Any liability related to SANYO products, including design and
quality, is the sole responsibility of Funai Electric Co., Ltd. and
Funai Corporation, Inc.
Please contact Funai Corporation, Inc. for any questions or
claims related to SANYO products: sanyo-av.com
Funai Corporation reserves the right to change products at any
time without being obliged to adjust earlier supplies accordingly.
The material in this Owner’s Manual is believed adequate for the
intended use of the system. If the product or its individual
modules or procedures are used for purposes other than those
specified herein, confirmation of their validity and suitability must
be obtained. Funai Corporation warrants that the material itself
does not infringe any United States patents. No further warranty
is expressed or implied.
Funai Corporation cannot be held responsible neither for any
errors in the content of this document nor for any problems as a
result of the content in this document. Errors reported to Funai
Corporation will be adapted and published on the Funai
Corporation support website as soon as possible.
Pixel characteristics
This LCD product has a high number of color pixels. Although it
has effective pixels of 99.999% or more, black dots or bright
points of light (red, green or blue) may appear constantly on the
screen. This is a structural property of the display (within
common industry standards) and is not a malfunction.
Warranty
No components are user serviceable. Do not open or remove
covers to the inside of the product. Repairs may only be done by
Service Centers and official repair shops. Failure to do so shall
void any warranty, stated or implied.
Any operation expressly prohibited in this Owner’s Manual, any
adjustments or assembly procedures not recommended or
authorized in this Owner’s Manual shall void the warranty.
Federal Communications Commission Notice
This equipment has been tested and found to comply with the limits
for a Class B Digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the
receiver.
•
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
•
Consult the dealer or an experienced radio or television
technician for help.
Declaration of conformity
Trade name
: SANYO
Responsible party
: Funai Corporation, Inc.
Model
: FW55C46F, FW43C46F
Address
: 12489 Lakeland Road, Santa Fe Springs,
CA 90670, USA*
Telephone number
: 1 866 212 0436
*
This is not the mailing address for Open Source Software or Customer
service.
Modifications
This apparatus may generate or use radio frequency energy.
Changes or Modifications to this apparatus may cause harmful
interference.
Any Modifications to the apparatus must be Approved by Funai
Corporation.
The user could lose the authority to operate this apparatus if an
unauthorized Change or Modification is made.
Cables
Connections to this device must be made with shielded cables
with metallic RFI / EMI connector hoods to maintain compliance
with FCC Rules and Regulations.
Canadian notice
CAN ICES-3 (B)/NMB-3 (B)
Analog and Digital Television Receiving Apparatus, Canada BETS-7 /
NTMR-7.
The following FCC/IC RSS applies to the
Wireless LAN adapter included in this product.
FCC Caution: Any changes or modifications not
expressly approved by the party responsible for
compliance could void the user’s authority to operate
this equipment.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Country Code Statement
For product available in the USA market, only channel 1
∼
11
can be operated. Selection of other channels is not
possible.
To maintain compliance with FCC RF exposure
requirements, use only belt-clips, holsters or similar
accessories that do not contain metallic components in its
assembly. The use of accessories that do not satisfy these
requirements may not comply with FCC RF exposure
requirements and should be avoided.
This device complies with Industry Canada
license-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not
cause interference and (2) this device must accept any
interference, including interference that may cause
undesired operation of the device.
5
.
English
Содержание FW43C46F
Страница 57: ...A5DREUH A5DVEUH ...
