Sanyo FW32D08F, Руководство пользователя

Страница: 34 / 39

6 Useful tips
FAQ
Question Answer
My remote control does not
work.
What should I do?
●
Check the antenna or cable connection to the main unit.
●
Check the batteries on the remote control.
●
Re-insert or replace the AAA batteries with their polarities (+/–) as indicated on the remote control battery area.
●
Check if there is an obstacle between the infrared sensor window and the remote control.
●
Test the IR signal output use IR signal check .
L
p. 36
If okay, then possible infrared sensor trouble.
●
Aim the remote control directly at the infrared sensor window on the front of the unit.
●
Reduce the distance to the unit.
●
When there is an infrared-equipped device such as PC near this unit, it may interrupt the remote control signal on this
unit. Move the infrared-equipped device away from this unit, change the angle of the device's infrared sensor or turn off
the infrared communication function.
How come the initial setup
appears every time I turn on
this unit?
●
Connect the RF coaxial cable directly to this unit and run the initial setup.
●
Make sure to complete the initial setup before the unit goes into standby mode.
Why can I not watch some
RF signal TV programs?
●
Autoprogram must be completed when you set up the unit for the first time or move it to a location where previously
unavailable channels are broadcast.
●
Make sure
Autoprogram
has been completed. L
p. 23
●
The selected channel may not be broadcasting.
●
When Autoprogram is interrupted and not completed, some channels will not be received. Make sure to complete the
Autoprogram. L p. 23
●
The selected channel cannot be viewed by the Child and ratings lock setting. L p. 26
●
The unit requires some kind of antenna input. An indoor antenna (Digital or VHF / UHF), an external antenna (Digital or
VHF / UHF) or an RF coaxial cable from your wall cable or set-top box needs to be plugged into the unit.
How come there is no
image from the connected
external devices?
●
Check if the correct input mode is selected by pressing SOURCE or using CH + / – . Refer to Watching channels from
an external device . L p. 17
●
Check the antenna, cable or other input connection to the unit.
●
When using the component video connection check that the green (Y), blue (Pb/Cb) and red (Pr/Cr) connectors are
connected to their corresponding colored jacks on the unit.
When I enter a channel
number, why does it
change automatically?
●
Many digital channels have alternate channel numbers. The unit changes the numbers automatically to the ones signifying
the broadcasting station's channel number. These basic numbers used for the previous analog broadcasts. (e.g., input
digital ch# 30 automatically changes to digital ch# 8.1)
Why are captions not
displayed entirely?
Or why are captions
delayed behind the dialog?
●
Closed captions that are delayed a few seconds behind the actual dialog are common for live broadcasts. Most captioning
production companies can display a dialog to maximum of 220 words per minute. If a dialog exceeds that rate, selective
editing is used to insure that the closed captions remain up-to date with the current TV screen dialog.
How can I set the clock?
●
There is no clock function on this unit.
My PIN code no longer
works, how can I change
the child lock setting?
●
If a Power failure occurs for longer than 10 seconds the child lock setting is retained, but the PIN code is reset to the
default code 0000. Refer to
Child and ratings lock
. L
p. 26
34 .
English
Continued on next page.