Sanyo EMO-SRT1, Руководство по обслуживанию

Страница: 9 / 24

- 12 -
Figure 12
H.REMOVING DOOR
I.RELEASING TYPE CONNECTOR
This oven is provided with locked type connectors.
When you remove a connector, pull the connector while
releasing the lock by pressing “A” point shown below.
Do not pull the wire of the connector.
Connector:
S1, S2, S102, S104 (Figure 13)
(1) Remove the cabinet(frame).
(2) Remove 2 screws securing the P.C.B for Power
with bracket to the cavity. (Figure 11)
Then take out it.
(3) Remove the both of spring hanging to the arm.
Note; When reinstalling the spring, be carefull of
direction of the tip of spring.
(4) To remove the arms, push the on its under the
door closing.
(5) Remove the 2 screws securing roller assembly
to detatch the both of hinge.
NOTES
- After replacing the door, be sure to check that the
interlock switch, the door sensing switch
and the interlock monitor swich operate normally.
(See pages 1 and 7)
- After replacing the door, check for microwave ene-
rgy leakage with a leakage detector. Microwave
energy leakage must be below the limit of
5mW/cm
2
.
A
Pull connector case (Never pull the wire)
A
Figure 13
Figure 14
Figure 15
J.DETECTOR (INFRALED SENSOR)
(1) When microwave operation is overheating, check
for surface of filter on infrared sensor and
mounting place of infrared sensor to the
cavity.
If the clouding the surface of filter on infrared
sensor, clean up the surface of filter using soft
cloth and secure the 2 screws infrared sensor
to ther mounting place certainly as shown in
figure 16.