Operation during programmed play
6. If you wish to start playing from a desired programme number, press the program
play button
then press one of the SKIP button
,
until the
desired programme number is indicated on the digital display.
7. If you wish to repeat one programmed track of the disc only, push the repeat
button
When this function is not worked,
programmed selection are
automatically repeated.
NOTE:
When you take out the disc, the memory for programmed play is auto-
matically cleared.
CAUTION
This player can not be operated with the HOT button pressed to ON while a
cassette tape is playing with the car stereo equipment connected to this player.
A disc can be inserted and loaded, but not played.
TROUBLE SHOOTING
The following checks will assist in the
of most problems which you may
counter with your unit. Should any problem persist after you have made these check
consult your nearest dealer.
Before going through the check list be first refer back to the connection operating
procedures.
Symptom
Cause
Solution
N o p o w e r .
The car’s ignition switch is
If the power supply is
not on.
to the car’s accessory
circuits, but the engine in not
moving, switch the ignition
key to “ACC”.
The fuse is blown.
Replace the fuse with another
5A fuse.
There is already a disc in the
Remove the disc in the player,
p l a y e r .
then put in the new one.
Disc cannot be
You are trying to put in the
Insert the Compact disc with
loaded or ejected.
c o m p a c t d i s c b a c k w a r d s .
the label side facing up.
The shipping screw is not
Remove the shipping screw.
removed.
The compact disc is
Clean the compact disc, try
ly dirty or defective disc.
to play the new one.
The temperature in the car
Cool off the inside of the
is too high.
car, then try again.
Condensation
Leave the disc player off for
an hour or so, then try again.
- 4 -
“
_
