CABINET
FIXING RING
LEADING RING
DRAIN HOSE
INNER HOSE
NAMES OF PARTS
1. TOP LID 2. WASH/SPIN TUB 3.TOP FRAME 4. BLEACH ENTRANCE
5.LINT FILTER 6. BASE 7. ADJUSTING FOOT 8. CONTROL PANEL
9. DRAIN HOSE 10.PULSATOR 11.HANDLE
2
3
After finishing to install the inlet hose, do not immediately switch on the power. Open the tap go over
the both ends with contact whether occur to seep. If the inlet hose is difficult to install for the tap etc. ,
you can invite the experienced person to help.
The method of installation for the double water inlet hose is the same.
The end of the hot water inlet hose is red color.
SIMPLE INSTALLATION AND OPERATION
Installation of the drain hose
Non-pump model
Pinch the FIXING RING by hand to make it loose and
engaged on the DRAIN HOSE and put the DRAIN HOSE
into the LEADING SKIRT of DRAIN HOSE in the bottom
of the washing machine to the end at the most (soak the
DRAIN HOSE in warm water will make the engagement
easy), and loosen the FIXING RING to let it clasp the
DRAIN HOSE.
1
2
3
4
5
6
8
10
9
7
11
Notices:
CONNECTOR
Tap
Installation of WATER INLET HOSE
1. Check the tap . Connect the CONNECTOR of WATER INLET HOSE with the tap.
2. Push the CONNECTOR of the WATER INLET HOSE upwards, and screw it into the tap tightly.
. Grasp the WATER INLET HOSE by hand and pull it downwards to see whether it is securely connected.
4. Connect the other end of the WATER INLET HOSE with the WATER INLET of the washing machine.
Notices:
Water tap may vary by country.
The appliance is to be connected to the water mains using new hose-sets and that old hose-sets not be
reused.
3
Accessories
WATER INLET HOSE
ASSEMBLY(2)
BASE COVER (1)
SELF-TAPPING SCREW (1)
